Uhu Plus Endfest 300 Two-component clear high-strength epoxy adhesive with high heat resistance 25 g

Product description Uhu Plus Endfest 300 Two-component clear high-strength epoxy adhesive with high heat resistance 25 g

Manufacturer	Uhu gmbh & co.
Packaging	1
Health hazard	Health hazard
Dangerous for the environment	Dangerous for the environment

The parts to be glued must be clean, dry and degreased. Remove the cap of the two-shot machine, squeeze out the filler and hardener in a 1:1 ratio (two equal strips) and mix properly. The adhesive has a workability time of 2 hours. Apply the adhesive on one side, or on both sides for rough and porous materials, pressing the two surfaces together and fixing (using clamps or tape). Clean and seal the ends of the two-shot machine properly. Curing time and final functional strength depend on the temperature supplied, see table. The minimum working temperature is 15°C. Store in a dry and cool place.

Manufacturer	Uhu gmbh & co.
Packaging	1
Health hazard	Health hazard
Dangerous for the environment	Dangerous for the environment

Contains:
filler: contains epoxy resin (m.h. 700) <100%
hardener contains: N,N-dimethyl-dipropylenetriamine <10%

Strength table depending on time and temperature:
20°C 12 h 120 kg/cm?
40°C 3 hours 150 kg/cm?
70 °C 45 min. 200 kg/cm?
100°C 10 min. 250 kg/cm?
180°C 5 min. 300 kg/cm?

Manufacturer	Uhu gmbh & co.
Packaging	1
Health hazard	Health hazard
Dangerous for the environment	Dangerous for the environment

Keep out of the reach of children. In case of contact with eyes, rinse immediately with water and seek medical attention. In case of contact with skin, wash immediately with plenty of soap and water. If swallowed, do not induce vomiting and seek medical attention immediately. Wear suitable protective gloves and goggles. Do not pour down drains.