Probazen Liquid Flocculant, 1 l

One of the most common problems encountered while taking care of pool water is the formation of cloudiness caused by the presence of fine mechanical or organic impurities or residues after the elimination of algae. By using the product LIQUID FLOCULANT, these fine particles are converted into a form that can be removed by filtration on sand or possibly cartridge filters. Before adding the product to the pool, it is necessary to first adjust the water pH to 6.5-6.8 using pH MINUS or pH PLUS according to the instructions on the packaging of these products.

Dosing:
Depending on the degree of water pollution, dose 10-50 ml of the LIQUID FLOCULANT for every 10 m3 of water in the pool. The measured dose is diluted in water (50-100 ml of product per 1 liter of water) and evenly dispersed over the surface of the pool while the water circulation is turned on for about 4 hours to allow the product to mix with the water. Then, turn off the circulation for 12 hours. During this time, flakes of precipitated impurities will form in the water, which can then be sucked out with a pool vacuum or captured during filtration. If it was not possible to adjust the water in the pool to the desired quality, the entire process is repeated.

Product Safety Warnings (H-statements)

• H315: Causes skin irritation.
• H319: Causes serious eye irritation.

Safe Handling Instructions (P-statements)

• P101: If medical advice is needed, have product container or label at hand.
• P102: Keep out of reach of children.
• P280: Wear protective gloves/protective clothing/eye protection/face protection.
• P302+P352: IF ON SKIN: Wash with plenty of water and soap.
• P305+P351+P338: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.