AgroBio Silwet Star organosilicone wetting agent, increases wettability and adhesion of application liquid 10 ml

Application notes
Use according to the instructions for use of the plant protection product. Silwet Star is used with fungicides, insecticides, acaricides, herbicides or desiccants in concentrations of 0.01 - 0.15% in the application liquid depending on the amount per 100 m2 The maximum permissible concentration is 0.15% in the application liquid and the rate must not exceed 3 ml per 100 m2. Usually a dose of 1 ml of Silwet Star per 100 m2 is used. Application of a fungicide, insecticide, acaricide herbicide or desiccant to which Silwet Star is added. Silwet Star is intended for application with fungicides, insecticides, herbicides or desiccants in all indications. During application, other vegetation in the vicinity of the treated area must not be affected.

Application
The adjuvant can be applied with conventional sprayers and dew sprinklers to ensure even application. As this adjuvant is toxic to aquatic organisms, the application liquid must not contaminate watercourses and the surface of water tanks with the chemical or packaging used. The adjuvant shall not be applied with any pesticide in or near water.

Preparing the application fluid
Observe the following filling of the application equipment tank:

1. Fill the tank to half the required volume with water.
2. Add pesticide or fertiliser as recommended in the instructions.
3. Fill the tank to about 90% of the required volume with constant stirring.
4. Add Silwet Star and stir for 1 to 2 minutes at a lower speed.
5. Add the remaining water up to 100% of the required volume.

It is recommended to carry out a phytotoxicity test on a small portion of the stand or a few plants under conditions that can be expected when using the test mixture, well in advance of treatment. A lower water dose, when the dosage of the product is observed, may increase the risk of phototoxicity, especially if the application conditions of the pesticide (temperature, humidity, growth phase, etc.) are not observed.)

The product must not be used for purposes other than those specified in this instruction manual.