Ratimor Brodifacoum paraffin blocks rodent bait, 300 g

Extruded paraffin blocks with shaped edges that allow rodents to gnaw. They are exceptionally effective, even when exposed to moisture or high temperatures.

Key properties of Ratimor Brodifacoum rodent bait:

• High effectiveness even with small amounts (with a single consumption),
• high resistance to environmental influences (especially suitable for damp places and outdoor use),
• contains a preservative that prevents mold and protects the bait from bacteria and fungi,
• delayed effect, which additionally increases the effectiveness of the bait,
• contains a bitter aversive agent.

Use of Ratimor paraffin blocks for rodents:

Before using the product, read the information about the product and all information attached to the product or provided at the point of sale and follow them. Before using rodenticides, consider non-chemical methods of control (e.g., traps). Remove food that is easily accessible to rodents (e.g., spilled grain or food waste). In addition to these measures, do not clean the infested area just before starting the rodent control, as this will only disturb the rodent population and make it harder for them to accept the bait. Rodent control stations should be placed in close proximity to areas where rodent activity has been observed (e.g., pathways, nesting sites, feeding places, holes, burrows, etc.). If possible, rodent control stations must be secured to the ground or to other structures. Place rodent control stations out of the reach of children, birds, pets, livestock, and other non-target animals.

Do not place rodent control stations near food, drinks, and feed or tools or surfaces that come into contact with them. Do not place rodent control stations near drainage systems where they may come into contact with water. When using the product, do not eat, drink, or smoke. After using the product, wash your hands and any skin that has come into direct contact. At the end of the rodent control period, remove any remaining bait or rodent control stations. Consider preventive control measures (seal holes, remove any food and drinks as far away as possible) to increase bait intake and reduce the likelihood of re-infestation.

Do not use the product as a permanent bait to prevent rodent infestations or to monitor rodent activity. Intended for use only in rodent control stations resistant to tampering. Label rodent control stations in accordance with the recommendations provided with the product. When using this product, rodents should be eliminated within 35 days. If, at the end of the rodent control, the user suspects that the product's effectiveness is insufficient (i.e., if they still observe rodent activity), they should seek advice from the product supplier or contact a rodent control service. During rodent control, search for and remove dead rodents at least as often as you check the rodent control stations. Dispose of dead rodents as hazardous waste by delivering them to an incinerator certified for hazardous waste disposal.

Application method for Ratimor rodent bait:

Bait for direct use in tamper-resistant rodent control stations.

Indoors (Brown rat and Common rat):

10 g - 60 g of bait per rodent control station. If more rodent control stations are needed, they must be at least 10 meters apart, except reduced to 5 meters in cases of high infestation. Rodent control stations must be checked no earlier than 5 to 7 days after starting rodent control and then at least once a week to verify if the bait is accepted, if the rodent control stations are intact, and to remove the bodies of dead rodents. Replenish the bait if necessary. Do not use the product for rodent control as a permanent or pulse bait application.

Outdoors around buildings (Brown rat and Common rat):

10 g - 60 g of bait per rodent control station. If more rodent control stations are needed, they must be at least 10 meters apart, except reduced to 5 meters in cases of high infestation. Place rodent control stations in areas where flooding is not a risk. Replace the bait in the rodent control station if it has been damaged by water or contaminated by dirt. Rodent control stations must be checked no earlier than 5 to 7 days after starting rodent control and then at least once a week to verify if the bait is accepted, if the rodent control stations are intact, and to remove the bodies of dead rodents. Replenish the bait if necessary. Do not use the product for rodent control as a permanent or pulse bait application.

Warning:

Use biocidal products safely. Always read the label and product information before use.

Product safety warnings (H-statements)

• EUH208: Contains (see dangerous substances). May cause an allergic reaction.
• H373: May cause damage to organs with prolonged or repeated exposure.

Safety handling instructions (P-statements)

• P260: Do not breathe dust/fume/gas/mist/vapours/aerosols.
• P314: If you feel unwell, seek medical advice/attention.
• P501: Dispose of contents/container according to instructions on the product.