Savo pool pH+ increases pH value, 1.2 kg

Savo pH+ is intended for increasing the pH value of pool water. The ideal pH range for pool water should be between 7.1 – 7.5. Use the product if the pH value is below this limit. By maintaining the correct pH range, the proper functioning of chlorine pool chemistry is ensured.

Recommended dilution:
By using Savo pH+ at a rate of 10 g/m3 of water, the pH can be increased by approximately 0.2-0.4. Dissolve the product in a container of water and then apply it to the pool. Keep the filtration system running and after sufficient mixing throughout the pool volume, perform a control measurement of the pH and, if necessary, apply the product again. Wear protective gloves and goggles. Always dose the product into prepared water and not vice versa. Never mix with other products. Always store in a closed container in a dry place protected from direct sunlight at temperatures of 5 – 25°C and out of reach of children. Do not smoke, eat, or drink while working with the product.
Dosing depends on the initial pH and the overall chemical composition of the water.

Product safety warnings (H-phrases)

• H319: Causes serious eye irritation.

Safety handling instructions (P-phrases)

• P101: If medical advice is needed, have product container or label at hand.
• P102: Keep out of reach of children.
• P260: Do not breathe dust/fume/gas/mist/vapors/aerosols.
• P305+P351+P338: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
• P313: Seek medical advice/attention.
• P501: Dispose of contents/container in accordance with local regulations.