Hlubna Valea Herbala Cold Wave with Plant Extract Permanent Wave, 100 ml

Lightly trim the hair, especially in case of split ends after coloring or bleaching. Gently wash the hair with shampoo, do not massage the scalp and lightly towel dry. Gradually separate individual hair strands, smooth them out, and start rolling

1. from the crown towards the neck,
2. from the crown to the forehead, and only then roll the sides.

Strands must have the same thickness and width as the rollers. Roll the strands on the rollers up to the roots of the hair, being careful not to pull too tight. Secure the rollers with a rubber band.

Applying Cold Wave
Apply a thicker layer of greasy cream around the rolled hair and wrap it with a strip of cotton. Starting at the nape of the neck, carefully and evenly moisten hair from roller to roller using a sponge. Clean any soiled areas of the scalp with a cotton pad and remove the protective strips of cotton. For better effect, cover the rolled hair with a napkin, scarf, or plastic cap, and to retain the heat generated, cover with a textile scarf or towel. Never artificially heat the permanent wave.

Processing time is counted from the moment of applying the Cold Wave solution.
The solution should act for 15-45 minutes depending on the quality and thickness of the hair. After the minimum processing time, check the effectiveness by unrolling one roller, preferably at the crown of the head. If the test strand is sufficiently waved, proceed to rinsing. If it is not sufficiently waved, let the permanent wave continue to work. However, never exceed the maximum processing time!

Rinsing
After the processing time is over, thoroughly rinse the rolled hair on the rollers with lukewarm water, let the water drip off, and carefully absorb the rest with a towel.

Fixation
Wrap a new strip of cotton around the skin near the rollers. Cut the tip of the cap from the bottle of fixative. From the nape of the neck, evenly apply the fixative from roller to roller. Apply about 2/3 of the contents of the bottle and let it act for 10 minutes. Then carefully unroll the rollers, do not pull the strands, and apply the remaining fixative to the hair, lightly knead the hair and let it act again for 5 minutes.

Washing
Thoroughly rinse the hair with lukewarm water and then wash with shampoo. After finishing the curling process, we recommend using a moderate amount of Valea Hair Cream, which should be rubbed into the hair and rinsed off with lukewarm water after 5-10 minutes. You will achieve soft and silky hair. After carefully performing all the described steps, the hair is ready to be dried and styled for the final touch.