Hlubna Valea Jita Cold Wave Permanent Wave with Plantain Extract, 100 ml

Lightly trim the hair, especially in the case of split ends after dyeing or bleaching. Gently wash the hair with shampoo, do not massage the scalp and lightly towel dry. Gradually separate individual strands of hair, smooth them out and start curling

1. from the crown of the head towards the neck,
2. from the crown to the forehead and then curl the sides.

The strands must be the same thickness and width as the roller. Curl the strands onto the rollers up to the roots of the hair, do not tighten too much. Secure the rollers with a rubber band.

Application of Cold Wave
Apply a thicker layer of greasy cream around the curled hair and wrap it with a strip of cotton. Start applying the Cold Wave solution using a sponge from the nape of the neck, carefully and evenly dampen the hair roller by roller. Clean any stained skin areas with a cotton pad and remove the protective strips of cotton. For better effect, cover the curled hair with a napkin, scarf, or plastic cap, and to retain the heat generated, cover it again with a cloth scarf or towel. Never artificially heat the permanent.

Processing time counts from the moment the Cold Wave solution is applied.
The solution should act for 15-45 minutes depending on the quality and strength of the hair. After the minimum processing time has passed, check the effectiveness by unrolling one roller, preferably on the crown of the head. If the test strand is sufficiently curled, proceed to rinsing. If it is not sufficiently curled, let the perm continue to act. However, never exceed the maximum processing time!

Rinsing
After the processing time is complete, thoroughly rinse the curled hair on the rollers with lukewarm water, let the water drain off and gently blot the rest with a towel.

Fixation
Wrap the skin around the rollers with a new strip of cotton. Cut the tip of the cap of the fixative bottle. Starting from the nape of the neck, evenly apply the fixative roller by roller. Apply about 2/3 of the content of the bottle and let it act for 10 minutes. Then gently unwind the rollers, do not pull the strands and apply the remaining fixative to the hair, lightly knead the hair and let it act again for 5 minutes.

Washing
Thoroughly rinse the hair with lukewarm water and then wash it with shampoo. After finishing the curling process, we recommend using a moderate amount of Valea Hair Cream, which should be rubbed into the hair and rinsed off with lukewarm water after 5-10 minutes. You will achieve soft and silky hair. After carefully performing all the described steps, the hair is ready for drying and final styling.