Motip 04019 spray for wheels black mat, 500 ml

Characteristics of Motip 04019 spray for wheels black mat:

• High quality, fast-drying nitro combi paint.
• Good flow, smooth surface.
• Weather-resistant, light-resistant (does not yellow).
• Limited fuel resistance.
• Good color and gloss retention.
• Hard surface, abrasion resistant.

Physical and chemical properties of Motip spray for wheels:

• 500 ml is sufficient for 4-5 wheels.
• Dust resistant: approximately after 5-10 minutes.
• Non-tacky: approximately after 10-20 minutes.
• Cured: after 24 hours.
• Subsequent coat with a clear lacquer: approximately after 2 hours.
• Drying time depends on ambient temperature, humidity, and thickness of the applied coat.
• Heat resistant: up to 110 °C.

Surface preparation:

• Carefully clean the wheels from dirt, grease, and brake dust.
• The surface must be sanded, clean, dry, and free of grease.
• Mask the edges of the wheels with masking tape.
• Apply a suitable primer.
• After drying, lightly sand the surface (sandpaper grit P600).

Painting:

• The surface must be clean, dry, rust-free, and grease-free.
• Before use, shake the container vigorously for 2 minutes.
• Test color compatibility.
• Apply several thin layers at intervals of 3 - 5 minutes from a distance of approximately 25 cm.
• After 60 minutes of drying, apply lacquer to protect the metal pigments in the paint.
• Do not spray on synthetic paints.

Product safety warnings (H-phrases)

• EUH066: Repeated exposure may cause skin dryness or cracking.
• H222+H229: Extremely flammable aerosol. Container is under pressure: may burst if heated.
• H319: Causes serious eye irritation.
• H336: May cause drowsiness or dizziness.

Safe handling instructions (P-phrases)

• P102: Keep out of reach of children.
• P210: Protect from heat, hot surfaces, sparks, open flames, and other sources of ignition. No smoking.
• P211: Do not spray into an open flame or other sources of ignition.
• P251: Do not pierce or burn, even after use.
• P260: Do not breathe dust/fume/gas/mist/vapor/aerosol.
• P410+P412: Protect from sunlight. Do not expose to temperatures exceeding 50 °C/122 °F.
• P501: Dispose of contents/container according to product instructions.