Ceys Metal Defect Repair Synthetic Metal, Filler, 40 ml + 40 g

This synthetic metal represents a two-component resin developed for the repair of metal surfaces. It handles cold welding (aluminum, copper), seals, bonds, and reliably fills cracks. At the same time, it creates a protective layer that prevents corrosion. It is characterized by resistance to acids, cleaning agents, and minerals, and does not crumble even after a long time. The cured material offers a metallic appearance and can be drilled, sanded, polished, and painted over. The filler with metallic filler consists of metal powder (plastic bottle) along with the resin (tube). The consistency of the prepared mixture can be adjusted according to the intended method of use.

To achieve a thick consistency, a larger proportion of metal powder is chosen, and the resulting mass is applied with a spatula or knife. Conversely, a liquid consistency is obtained by mixing a small amount of metal powder with a larger volume of resin. The prepared mixture hardens in approximately 30 minutes and is excellent for both impregnation and anti-corrosive protection of large areas. A brush, roller, or syringe can be used for application. In the case of application with a spray gun, it is necessary to add 5 - 10% acetone to the mixture.

• Resistant to extreme temperatures (from -50 °C to +150 °C), acids, detergents, and mineral products
• Does not crack over time
• Color: gray/aluminum
• Tensile strength: ±442 kg/cm²
• Bending strength: ±420 kg/cm²

For materials:
metal and its agglomerates. Iron, copper, brass, bronze, alloys

Instructions for use:
Synthetic metal consists of metal powder (plastic container) and resin (metal tube). The consistency of the mixture may vary depending on how the product will be used.

1. CLEAN AND THOROUGHLY DRY THE SURFACES TO BE TREATED. In the case of renovations and highly glossy surfaces, it is recommended to sand the substrate before application.
2. In the plastic container, mix the powder with the resin in the chosen ratio until a completely homogeneous mass is formed. Depending on the intended use, a more liquid variant (for pouring or protection) may be necessary, or rather a thicker consistency (for gluing, filling…).
3. It is crucial to always achieve a perfectly homogeneous mixture. The processing time depends on the chosen ratio of components and on the ambient temperature; at higher temperatures, the usability and curing time shorten. An indicative overview is provided in the following table (insert filler table).
4. Apply Synthetic Metal layer by layer with a spatula to the prepared substrate and let it dry for a few minutes. The curing speed is affected by the density of the prepared mass: the thicker the mixture, the shorter the drying time.
5. Once the product has cured, you can sand, drill, polish, and repaint it.
6. Clean used tools and any remaining material with universal thinner.

For coloring:
Synthetic metal can be painted on the surface; before applying liquid paints, it is sufficient to sand the cured substrate.

Product safety warnings (H-statements)

• H226: Flammable liquid and vapors.
• H315: Causes skin irritation.
• H317: May cause an allergic skin reaction.
• H319: Causes serious eye irritation.
• H332: Harmful if inhaled.
• H335: May cause respiratory irritation.
• H360d: May harm the unborn child.

Precautions for safe handling (P-statements)

• P102: Keep out of reach of children.
• P210: Keep away from heat, hot surfaces, sparks, open flames, and other ignition sources. No smoking.
• P280: Wear protective gloves/protective clothing/protective eyewear/face shield.
• P301+P312: IF SWALLOWED: If you feel unwell, call a TOXICOLOGY INFORMATION CENTRE/doctor
• P302+P352: IF ON SKIN: Wash with plenty of water and soap
• P305+P351+P338: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.