Polykar Super Plus fine two-component polyester filler, 200 g

Fine filler for filling small unevenness, grooves, and pores. Designed for common substrates including cast iron, aluminum, zinc, and fiberglass. Usable also for leveling unevenness in wood (harder types), laminate, concrete, etc. Due to its fine structure, it is very well applicable. Suitable for model makers.

The filler must not be used for filling areas that come into direct contact with food and drinking water.

Application:
The surface must be free from rust and sanded with P80 sandpaper. The surface must be clean, dry, and free of dust and grease. For maximum corrosion protection, first use an epoxy or polyurethane base. Do not apply the filler on reactive, single-component, and nitrocellulose bases. It is applied with a spatula.

Curing:
The filler is cured with a hardener (PE-initiator, dibenzoyl peroxide, red paste in a tube) in a weight ratio of 100:2 - 100 parts of filler: 2 parts of hardener – recommended ratio for a temperature of 23°C.

Working time:
The filler must be processed at a temperature of 23 °C and a curing ratio of 100:2 within 5 minutes after mixing with the hardener. At temperatures lower than 23 °C (at least 17 °C), the working time is extended, while at higher temperatures it is shortened. By adjusting the curing ratio, the effect of temperature on the working time can be partially eliminated.

Curing ratio:
- at least 100:1 – extends the working time
- at most 100:3 – shortens the working time

Sanding:
The filler can be sanded at a temperature of 23 °C and a curing ratio of 100:2 within 20-30 minutes. Rough sanding starts with P80-120 sandpaper and is finished with 180-240 paper. For sanding, we recommend using a rotary or orbital sander.

Top coating:
All common coating systems can be used on the filler. The filler withstands temperatures from 80 to 110 °C.

Cleaning:
Contaminated parts of tools can be cleaned with POLYKAR POLYESTER THINNER or nitro thinner C6000. Only uncured filler can be cleaned.

Product safety warning (H-statements)

• EUH212: Warning! A dangerous respirable dust may be formed during use. Do not breathe dust
• H315: Causes skin irritation.
• H319: Causes serious eye irritation.
• H361d: Suspected of damaging the fetus in the womb through inhalation.
• H372: Causes damage to organs with prolonged or repeated exposure.

Safety handling instructions (P-statements)

• P101: If medical advice is needed, have product container or label at hand.
• P102: Keep out of reach of children.
• P260: Do not breathe dust/fume/gas/mist/vapors/aerosols.
• P270: Do not eat, drink or smoke when using this product.
• P280: Wear protective gloves/protective clothing/eye protection/face protection.
• P302+P352: IF ON SKIN: Wash with plenty of water and soap
• P305+P351+P338: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
• P308+P313: IF exposed or concerned: Get medical advice/attention.
• P405: Store locked up.
• P501: Dispose of contents/container in accordance with local regulations.