REMAL Telsal neutralizing salt for stains V2026, 3 kg

Neutralizing salt for wall stains. The agent is intended for the neutralization of fresh dried plaster against the efflorescence of water-soluble salts and lime from plasters and for the remediation of color stains from smoke, nicotine, and leaking water. The agent can be used under painter's preparations and dispersion facade paints.

The agent is non-toxic, but not intended for direct contact with food, feed, and drinking water. It is irritating to unprotected skin and solutions of higher concentrations can be caustic. In case of accidental ingestion, damage to the digestive system may occur. Observe basic personal hygiene. Do not eat, drink, or smoke while working. After working with the agent, wash your hands with water and soap.

Properties of the stain removal agent:

• for water stains on walls
• neutralizes fresh plasters
• removes stains from leaking water, smoke, and nicotine
• can be used under painter's preparations and dispersion facade paints
• plaster substrate
• interior and exterior environment
• dilution with water for dissolution
• application method Brush, paintbrush
• packaging 3 kg

Approximate coverage:

up to 150 to 200 g/m2 of dissolved preparation for one coat.

Application procedure of the stain removal agent:

Before using the stain remover, the surface must be free from loose parts, dust, grease, and must be dry; older coatings in larger layers must be scraped off. REMAL TELSAL V2026 is dissolved at a ratio of 1 kg in 5 l of water, and the prepared solution is applied to the treated surfaces.

In case of swelling of old coatings (especially paint, etc.), it is necessary to clean these before further coating. Always use only as much of the solution as needed to prevent dripping and creating glossy, hard-to-overpaint areas with excess REMAL TELSAL V2026! In this case, swelling of the top coats may occur. After drying the treated or cleaned surface, common painter's preparations, dispersion or silicone facade paints can be applied in the usual manner. It is not suitable to use under silicate facade paints.

Storage of the stain and blemish remover:

The product retains its utility properties for 5 years from the date of manufacture, in the original unopened packaging. Store in a dry place at a temperature of 5 to 25 °C.

Product safety warnings (H-statements)

• H314: Causes severe skin burns and eye damage.
• H318: Causes serious eye damage.

Instructions for safe handling (P-statements)

• P101: If medical advice is needed, have product container or label at hand.
• P102: Keep out of reach of children.
• P280: Wear protective gloves/protective clothing/eye protection/face protection.
• P301+P310+P331: IF SWALLOWED: Immediately call a POISON CENTER/doctor. DO NOT induce vomiting.
• P303+P361+P353: IF ON SKIN (or hair): Remove contaminated clothing immediately. Rinse skin with water/shower.
• P305+P351+P338: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
• P310: Immediately call a POISON CENTER/doctor