Detecha Superkov basic and topcoat for metal, green matte, 5 kg

Basic and top anti-corrosive synthetic paint for metal designed for the surface treatment of metal materials and their effective protection against the formation of corrosion. It creates a high barrier effect against the permanent influence of weather conditions and sunlight. For long-term protection (up to 8 years), 2 - 3 layers of Superkov are sufficient without a prior primer. SUPERKOV is a basic and top anti-corrosive coating for metal, sheet metal roofing, steel structures, gutters, etc.

Metal paint properties:

• Alkyd coating material with a higher solid content.
• Acts as a high-quality anti-corrosive base and simultaneously as a top protective coating with a high barrier effect.
• Contains effective corrosion inhibitors, including UV ray absorbers that combat the degradation of the coating due to weathering.
• SUPERKOV requires no base or subsequent top coatings

Usage:
Basic and top coatings for sheet metal roofing, steel structures, gutters, fences, and all metal objects exposed to permanent weather influences (including sunlight) without prior treatment with a primer. Freshly galvanized sheet metal should be painted after one year of exposure to weather influences or after prior surface treatment with a suitable product.

Dilution:
S 6005, S 6006

Coverage:
Theoretical coverage for one layer is 7 – 9 m² per 1 kg of coating material at a usual dry film thickness of 40 – 50 µm (the corresponding wet thickness is 75 - 100 µm). Actual coverage depends on the quality of the substrate and the method of application. Maximum durability can be achieved with proper application and a minimum thickness of 150 μm of dry coating.

Substrate preparation and application method:
The surfaces to be painted must be dry, degreased, and free from dirt, rust, and old non-adhering coatings. Before use, the contents of the can should be thoroughly mixed, and if necessary, diluted slightly to the needed consistency. The coating is applied with a brush, roller, or spraying in two to three layers at a temperature of +5 to +25 °C. Do not work in direct intense sunlight! The interval between individual coatings is a minimum of 6 hours at a temperature of 20 °C. The coating becomes touch dry in 4 hours and cures in 24 hours. When painting large continuous areas, it is recommended to use products from the same production batch, or to mix the contents of individual packages to achieve color homogeneity. Surfaces that are heavily corroded or difficult to clean should be pre-treated with the anchoring polyurethane product Fest primer. This increases the quality and lifespan of the entire coating system.

Warning:
The manufacturer is not liable for defects caused by failure to follow the recommended technological procedures and general conditions for applying coating materials.

Product safety warnings (H-statements)

• EUH066: Repeated exposure may cause drying or cracking of the skin.
• H226: Flammable liquid and vapors.
• H319: Causes serious eye irritation.
• H336: May cause drowsiness or dizziness.
• H411: Toxic to aquatic life with long-lasting effects.

Safety handling instructions (P-statements)

• P102: Keep out of reach of children.
• P210: Keep away from heat, hot surfaces, sparks, open flames, and other ignition sources. No smoking.
• P271: Use only outdoors or in a well-ventilated area.
• P280: Wear protective gloves/protective clothing/eye protection/face protection.
• P301+P330+P331: IF SWALLOWED: Rinse mouth. DO NOT induce vomiting.
• P302+P352: IF ON SKIN: Wash with plenty of water and soap
• P305+P351+P338: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
• P312: Call a POISON CENTER or doctor if you feel unwell.
• P391: Collect spillage.
• P501: Dispose of contents/container in accordance with the product instructions.