Het Hetmal Plus paint, 4 kg

The white interior dispersion paint Het Hetmal Plus with high opacity is recommended for residential and commercial spaces, offices, school buildings, corridors, and for industrial use. Het Hetmal Plus is used for painting ceilings and walls, lime and lime-cement plasters, concrete monoliths and panels, or designated paper wallpapers, etc. The coating can also be applied to previously adhered layers of interior paints. The product meets the requirements for surface treatments that come into indirect and direct accidental contact with food. After application, a matte, vapor-permeable film is formed, which withstands the usual humidity in rooms and abrasion with a dry cloth. However, the treated surface must not be in permanent contact with water or exposed to condensing moisture. Once dry, it can withstand short-term exposure to temperatures around 70°C. Het Hetmal Plus is suitable for painting offices, schools, residential, commercial, and industrial buildings, corridors, etc. It is characterized by increased whiteness of 93% (MgO), high coverage, matte appearance, resistance to dry abrasion, vapor permeability, and easy tinting.

Color:
white, can be tinted using HETCOLOR tinting colors (max. up to a ratio of 1:5 parts paint)

Coverage:
8 - 12 m²/kg in one coat depending on absorption and substrate structure and the thickness of the applied layer

Drying time: 
at least 4 hours at 20 °C and 60% relative humidity

Application:
with a brush, paint rollers (perlon, polyacrylic, polyamide), small areas with a brush, large area application by AIRLESS spraying. When spraying, it is advisable to conduct preliminary tests on the specific equipment. The temperature of the material, environment, and substrate must remain within the range of +5 to +30 °C during application and for 24 hours after application.

Substrate:
dry, firm, clean, free from biological contamination (mold, algae), unsalted, non-greasy, free from formwork oils, chemically stable, matured (pH ≤8.5; a check can be performed with a pH tester).

Example of application procedure:

1. before application, always thoroughly mix the paint. When mixing, ensure that no air penetrates into the mass and that the paint does not foam.
2. the priming coat is performed with paint diluted with up to 0.5 l of water for 1 kg of paint. For smooth substrates, use a penetrating agent UP-GRUND for the priming coat; for very absorbent substrates, use agents A-GRUND or AT-GRUND. If the substrate is a cohesive, non-dusting, low-absorbing existing coating, a priming coat is not necessary. Layers
   of old coatings with insufficient adhesion must be scraped off beforehand. Stains from water leaks, rust, soot, aniline dyes, or nicotine should first be covered with an insulating coating I-GRUND or in the case of greater intensity with paint HETLINE IZOL.
3. after the priming coat has dried, apply 1 to 2, or according to need for new or significantly differently colored substrates even more, cover coats of paint diluted with a maximum of 0.3 liters of water per 1 kg of paint. WARNING: excessive dilution of the paint reduces opacity and may worsen the paint's parameters.
4. keep all tools protected against drying during breaks and clean them with water after use. Immediately wash any contaminated areas with water, as dried paint is difficult to remove. Ensure thorough ventilation during application and drying.