Detecha Ekoban wood and concrete paint, gray, 2.5 kg

Water-dilutable paint for concrete and other absorbent materials with moderate mechanical stress. The coating is flexible with very good adhesion to the substrate. It is water-resistant and vapor-permeable. A product with an excellent quality-price ratio.

Usage:
Coatings for concrete, concrete surfaces, especially concrete floors, vertical walls, and other absorbent materials subjected to moderate mechanical stress indoors. Also for wood, chipboard, and fiberboard. Using on non-absorbent and glazed concrete, ceramic tiles, and concrete treated with leveling compounds reduces adhesion and mechanical resistance of the paint film. Not recommended for use in permanently damp areas and in places where floors need to be cleaned with abrasive agents and machine washing. Not intended for coatings that come into direct contact with food, animal feed, drinking water, or for coatings on children's furniture and toys.

Substrate preparation and application method:
Concrete must be mature (min. 28 days), dry (max. 15% moisture), absorbent (unglazed), cohesive with a minimum tensile adhesion of 1.5 MPa, smooth without greasy stains from oils, etc. It must be free from all mechanical impurities and old coatings. Absorbent substrates must be treated with a primer. For this purpose, EKOBAN® diluted with water in a ratio of approximately 1:5 to 1:10 can be used. Add water gradually and mix during dilution. In case of higher absorbency of the substrate, the primer can be repeated until the product is absorbed. Before use, the coating material must be thoroughly mixed and diluted with water if necessary (max. 5%). It is applied with a brush, roller, or spraying in two or more layers at a substrate and ambient temperature of +10 to +25°C, always after the previous layer has dried. The temperature conditions must be maintained throughout the drying time of the coating! The drying speed depends on the applied thickness, temperature, humidity, and air circulation. The painted surface is walkable in approximately 8 hours. After 24 hours, the floor can be gradually subjected to mechanical loads. The final properties of the coating are achieved after 10 days of curing. We recommend applying the final layer with paint from the same production batch to eliminate possible color differences. To improve the washability of the floor and increase mechanical resistance, we recommend coating the final layer with Ekoban floor lacquer.

Note:
Perform the first primer coating with Ekoban diluted 1:5 – 1:15 depending on the substrate absorbency. Dilution should be done gradually while constantly mixing.

Coverage:
Coverage per layer is 5.5 - 7 m² per 1 kg of coating material and is influenced by the quality of the substrate and application technique.

Safety handling instructions (P-phrases)

• P102: Keep out of reach of children.
• P261: Avoid breathing dust/fume/gas/mist/vapors/aerosols.
• P273: Avoid release to the environment.
• P501: Dispose of contents/container according to product instructions.