Detecha Superkov basic and top coat for metal, gray matte, 5 kg

Basic and top anti-corrosive synthetic paint for metal designed for the surface treatment of metal materials and their effective protection against corrosion. It creates a high barrier effect against the permanent effects of weather conditions and sunlight. For long-term protection (up to 8 years), 2 - 3 coats of Superkov are sufficient without a prior primer. SUPERKOV is both a basic and top anti-corrosive coating for metal, metal roofing, steel structures, gutters, etc.

Properties of metal paint:

• Alkyd coating with a higher solid content.
• Acts as a quality anti-corrosive primer and at the same time as a top protective coating with a high barrier effect.
• Contains an effective corrosion inhibitor including a UV absorber that acts against the degradation of the coating due to weather conditions.
• SUPERKOV does not require any base or subsequent top coatings

Usage:
Basic and top coatings for metal roofs, steel structures, gutters, fences, and all metal objects exposed to lasting weather conditions (including sunlight) without prior treatment with a primer. It is recommended to paint freshly galvanized sheet metal after one year of exposure to the elements or after prior surface treatment with a suitable agent.

Dilution:
S 6005, S 6006

Yield:
Theoretical yield for one coat is 7 – 9 m² from 1 kg of coating material at the usual thickness of the dry film of 40 – 50 µm (corresponding wet thickness is 75 - 100 µm). Actual yield depends on the quality of the substrate and the method of application. Maximum durability can be achieved with proper application and a minimum thickness of 150 μm of dry coating.

Surface preparation and application method:
The surfaces to be painted must be dry, degreased, and free of dirt, rust, and old non-adhering coatings. Before use, the contents of the can must be thoroughly mixed, and if necessary, slightly diluted to the required consistency. The coating is applied with a brush, roller, or spray in two to three layers at a temperature of +5 to +25 C. Do not work in direct strong sunlight! The interval between individual coats is at least 6 hours at a temperature of 20 °C. The coating becomes tack-free within 4 hours, cures within 24 hours. When painting large continuous areas, it is recommended to use products from the same production batch or mix the contents of individual packages, thus homogenizing the color. Surfaces that are heavily corroded or difficult to clean should be pre-treated with the anchoring polyurethane product Fest primer. This will enhance the quality and durability of the entire coating system.

Warning:
The manufacturer is not responsible for defects caused by failure to adhere to the recommended technological procedures and general conditions for the application of coatings.

Product safety warnings (H-phrases)

• EUH066: Repeated exposure may cause skin dryness or cracking.
• H226: Flammable liquid and vapors.
• H319: Causes serious eye irritation.
• H336: May cause drowsiness or dizziness.
• H411: Toxic to aquatic life with long lasting effects.

Safety handling instructions (P-phrases)

• P102: Keep out of reach of children.
• P210: Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.
• P271: Use only outdoors or in a well-ventilated area.
• P280: Wear protective gloves/protective clothing/eye protection/face protection.
• P301+P330+P331: IF SWALLOWED: Rinse mouth. DO NOT induce vomiting.
• P302+P352: IF ON SKIN: Wash with plenty of water and soap
• P305+P351+P338: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
• P312: Call a POISON CENTER or doctor if you feel unwell.
• P391: Collect spilled product.
• P501: Dispose of contents/container in accordance with local regulations.