Het Fasadin facade paint with fine grain, white, 15 + 3 kg

Het Fasadin is a facade paint for outdoor coatings of lime, lime-cement, and břízolit plasters, plasters with acrylic binder, masonry, for decorative coatings of vertical concrete structures, etc. The coating creates a matte, fine-grained, vapor-permeable, fully washable surface, resistant to weathering, acid rain, and industrial emissions.
The paint is suitable for coating both new and old mineral plasters, for renovation coatings of acrylic facade paints, for unifying or renovating coatings of contact thermal insulation systems with a surface finish of acrylic thin-layer plaster. The paint film must not be in constant contact with water and rising moisture.

Shades:
white, tinting can be done with HETCOLOR tinting colors (only shades suitable for exteriors). The paint can also be tinted using tinting machines with HET color systems into pastel shades.

Thinner:
water (potable)

Application:
recommended application – facade painting rollers (perlon, polyacrylic, polyamide), brush; small areas – with a brush.

Coverage:
approximately 5 m² per 1 kg of paint in one coat. Coverage may vary depending on the absorbency and structure of the substrate, application technique, thickness of the applied layer, and other factors. The exact coverage for a specific substrate must be determined on a test area.

Substrate:
dry, cohesive, free from dirt and biological contamination (mold, algae), unsalted, grease-free, free of form oils, chemically stable, matured (pH ≤8.5; control can be done with a pH tester). For new plasters, it is necessary to remove loose grains of sand (by sanding or sweeping).

Example of application procedure:

1. A priming coat is applied using a penetrating agent according to the instructions for use. In the case of absorbent rough substrates, it is best to use a deep penetrating agent AT-GRUND, and for smooth or less absorbent substrates, a pigmented penetrating agent UP-GRUND. Universal penetrating agents A-GRUND or 100-GRUND can also be used. The priming coat should be left to dry completely for at least 12 - 24 hours.
2. After drying the priming coat, apply 2, or in the case of new or significantly differently colored substrates as needed, more, covering coats of paint diluted with a maximum of 0.05 liters of water per 1 kg of paint. WARNING: Excessive dilution of the paint reduces coverage and may worsen the paint's parameters. Before application, the paint must be properly mixed. When mixing, care should be taken to prevent air from entering the mass and to prevent bubbling of the paint.
3. All tools should be protected against drying during work breaks and washed with water after use. Spots should be washed immediately with water, as dried paint is difficult to remove.

Product safety warnings (H-phrases)

• EUH208: Contains (see hazardous substances). May cause an allergic reaction.

Instructions for safe handling (P-phrases)

• P101: If medical advice is needed, have product container or label at hand.
• P102: Keep out of reach of children.
• P501: Dispose of contents/container according to product instructions.