Het Mikral 100 facade paint, 7 kg

Het Mikral 100 facade smooth paint for exterior coatings of lime, lime-cement and brushed plaster, plasters with acrylic binder, masonry, for decorative coatings of vertical concrete structures, etc. The coating creates a matte, vapor-permeable, fully washable surface, resistant to weathering, acid rain, and industrial emissions. The paint is suitable for coatings of both new and old mineral plasters, for renovation coatings of acrylic facade paints, for unifying or renovation coatings of contact thermal insulation systems with a surface finish of acrylic thin-layer plaster. The coating film must not be in constant contact with water and rising moisture.

Shades:
white, tinting can be done with HETCOLOR tinting colors (only shades suitable for exteriors). The bases are intended for tinting using tinting machines in HET coloring systems.

Thinner:
water (potable)

Application:
recommended application – facade paint rollers (perlon, polyacrylic, polyamide), brush; small areas - by brush; large area application – by AIRLESS spraying. When spraying, it is advisable to conduct tests on the given equipment beforehand.

Coverage:
approximately 7 m² from 1 kg of paint in one layer. Coverage may vary depending on the absorbency and texture of the substrate, application technique, thickness of the layer applied, and other factors. The exact coverage for a specific substrate must be determined on a test area.

Substrate:
dry, cohesive, free of dirt and biological infestation (mold, algae), unsoiled, non-greasy, free of formwork oils, chemically stable, matured (pH ≤8.5; testing can be done with a pH tester). For new plasters, it is necessary to remove loose grains of sand (by sanding or sweeping).

Example application procedure:

1. A priming coat is applied with a penetrating agent according to the instructions for use. In the case of absorbent coarse substrates, it is best to use a deep-penetrating agent AT-GRUND, and for smooth or less absorbent substrates, a pigmented penetrating agent UP-GRUND. Universal penetrating agents A-GRUND or 100-GRUND can also be used. The priming coat should be left to dry completely for at least 12 - 24 hours.
2. After the priming coat has dried, apply 2, or for new or significantly different shades, more, covering coats of paint diluted with a maximum of 0.05 liters of water per 1 kg of paint. WARNING: excessive dilution of the paint reduces opacity and may worsen the paint's parameters. Before application, the paint needs to be properly mixed. During mixing, care should be taken to avoid air entrapment and foaming of the paint.
3. Protect all tools against drying out during work breaks and clean them with water after use. Immediately wash contaminated areas with water; dried paint is difficult to remove.